How to get a good print

A few small things in your 3D file make a big difference to how your part turns out. These are the ones we see most often.

1. Export in millimetres

We read your file in millimetres. If your part shows up 25 times too small on the upload page, it was drawn in inches: switch the units to in and the size and price update.

2. Use STL, 3MF, STEP or OBJ

We can show and price these straight away. IGES and GLB work too, but a GLB file doesn't say how big the model is, so check the size before you order. Have a part in several files? Drop them in together or send one ZIP, and they open as one set.

3. Keep walls at least 1.2 mm thick

The printer lays down lines about 0.4 mm wide, so a 1.2 mm wall is three lines side by side. Thinner walls print, but they break easily, and details much smaller than 0.4 mm may not show at all.

4. Leave room where parts meet

Plastic spreads a tiny bit when it is printed. As a starting point:

FitGap on each side
Parts that slide into each other0.2–0.3 mm
Screw holesabout 0.2 mm bigger than the screw
Tight press fittest with a small piece first

5. Watch the overhangs

Anything that sticks out at more than about 45 degrees needs support underneath, and the surface is a little rougher where the support touched. Often a chamfer or a slope does the same job and prints cleaner.

6. Give it a flat side

Every print starts on a flat plate. A part with a flat side prints steadier and stronger. We turn every part onto its best side for you, but a part with no flat side at all needs more support.

7. Mind the size

Our print area is 250 mm on each side. If your part is bigger, the upload page tells you, and we split it into pieces that fit together or email you first.

8. Pick the material for the job

A great file in the wrong material is still the wrong part. PLA for indoors, PETG for the garage and outdoors, TPU when it should bend. Our materials guide helps you choose.

Not sure about something? Ask us before you order. We would rather answer a question than print a part twice.